Tools for balances

Roller remover. Plier shaped.

Riveting stake. Hardened steel. 36 holes from 0.5 - 2.5 mm

Lyre truing caliper, for balancing the balances of watches. Brass sanded, chrom.-plated. Jewelled pivot protectors. Holes:0.15 mm.

Set of 3 spring tools for assembling / disassemblink KIF Trior

3 Diameters: 1,60 - 1,90 -2,10mm

Poising tool. Ruby jaws length 15 mm. Type of extra perfect finish with high precision. Spirit level diameter 18 mm. The spirit-level can be placed on the jaws.

Tool with jaws without notch.

Swiss made by Bergeon

4 different notches for tightening all sizes of hairspring collets and for reaming the hole.

Pin vice for holding hairspring
lenght: 105 mm

Tool for rounding the tips of balance pivots.

Bergeon n. 5482

Tool for the regulation of micrometric screws of balance like Rolex movements. With this instrument you can regulate the time to the perfection. 

Hairspring and jewel cleaner. Removes dirt and gum but does not dissolves the shellac. Leaves a protective film which shields the spring from rust due to sudden atmospheric changes or proximity to moisture. Absolutely non-inflammable. Contents 50 cm3

Balance support.

Enables the watchmaker to position the balance-cock with his balance-spring, avoiding to pollute the oil on the staff pivot, during the corrections.

Tool for the regulation of micrometric screws of balance Omega cal.8500.

With this instrument you can regulate the time to the perfection.

Tool for the regulation of micrometric screws of balance Omega cal.3303and coax. cla. 3313. With this instrument you can regulate the time to the perfection.

TOOL FOR SHOCKPROOF SPRING NOVODIAC

to use fo caliber eta: 2801 / 2804-2 / 2824-2 / 2836-2

TOOL FOR PRESSING OUT THE STUD FROM THE STUD SUPPORT ETACHRON

TOOL FOR SHOCKPROOF SPRING NOVODIAC

to use fo caliber  ETA 2660 - 2671 - 2688

TOOL FOR PRESSING OUT THE STUD FROM THE STUD SUPPORT ETACHRON

Hardened steel riveting stake with 36 calibrated holes from Ø 0.50 to 2.50 mm.

Dimensions: 53X15MM

Hardened steel riveting stake, with 20 calibrated holes from Ø 0.50 to 2.50 mm, 2 "V" shape slots and 5 notches of different dimensions.

Dimensions: 72X15MM

Tool to remove ETACHRON pitons

Horotec Short and extra-fine cobasteel tweezers for hairsprings. The new cobasteel alloy offers and exceptional strength and durability. - 100% antimagnetic - Corrosion resistant - Tip hardness 63/64 HRC.

Swiss Made

Horotec TWEEZERS FOR MARKING HAIRSPRINGS, No. 15

CARBON STEEL

L105 mm

Swiss Made